AESCO is a full service contract manufacturer with engineering services and also is a regional distributor for passive components. This combination enables AESCO to develop complete turnkey products for our customers base. We work with the customers to develop and build prototype assemblies (cables, harnesses, PCB’s, upper level assemblies and final assemblies). We specialize in high mix and low quantity production lot sizes so no opportunity is too small.

Currently on the floor we are producing large HLA (Higher Level Assemblies) frames. On these frames we incorporate smaller EMA’s, poly, cable, coax and fiber optic harnesses and special hardware configurations. We take two to four harnesses and massage them into one clean harness, feed through sub floors and along the frame. We manufacture a wide variety of chassis and raceways using PCB assemblies, pneumatics, fiber optics, coax and mechanical components.

• Weidmuller rail cutter and notcher. Capable of cutting various styles of rail to any length and applying a holes, slots or notches.
• 4 –adjustable height scissor lifts. These are used for heavy small to medium EMA’s.
• Yale Fork Lift. This is used to move the large frame EMA’s around the plant.
• 2 – Ton engine hoist. Used to lift heavy transformers.
• 25+ adjustable torque wrenches and drivers.
• 2 torque driver verifiers. These are used to verify all of the torque settings before they are used.

Using both AESCO and Customer owned test equipment, we will perform an electrical test based on your customer’s specifications. AESCO owns a wide variety of test equipment including Digital Oscilloscopes, Power Supplies and Signal Generators.